vax.co.uk
10
5. Remove the nozzle guard by removing the four (4)
screws. Look for any obstructions and remove brushbar if
necessary (Fig.8/5).
Clearing Blockages from the TurboTool
(Some models only)
1. Turn the TurboTool over and slide off the locking ring
(Fig.8/6).
2. Pivot lowering housing and remove clog (Fig.8/7).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the locking ring into the
groove at the neck of the TurboTool™ to complete
reassembly (Fig.8/8).
clearing blockages
Fig.8/5
LOCKING RING
Fig.8/6
Fig.8/7
TABS
Fig.8/8
U90-P5 & U90-P6 Series User Guide v1.2.qxd:UG 13/5/10 14:46 Page 10
