5
Vax Careline
0870 606 1248
operation
4. How to Operate
Turn the vacuum cleaner on by pressing the on/off switch
located on the lower right side of the cleaner (Fig.4/1).
The cleaner can be turned off by pressing the on/off
switch again.
Adjusting the Angle of the Main Body
To adjust the angle of the vacuum cleaner body, push the
release pedal on the lower left side of the cleaner (Fig.4/2).
Move the handle to the desired position. (A) for
upright position, (B) for normal operation and (C) to clean
under furniture (Fig.4/2).
Carpet Height Adjuster
The cleaning of carpet and rugs takes place at the nozzle.
When it is necessary to raise and lower the nozzle for
various carpet pile heights, place handle in upright position
and turn the carpet height adjuster to the desired setting
(Fig.4/3).
NOTE: The nozzle will not move into the adjusted
position until the cleaner handle is lowered to the
operating position.
WARNING:
To avoid injury, keep loose clothing, hair,
fingers and all other parts of the body away from
any moving part (such as the brushbar). Turn off the
switch and unplug the cleaner before adjusting the
cleaner for the carpet height.
On/ off
switch
Fig.4/1
Fig.4/2
Fig.4/3
!
A
B
C
WARNING:
This cleaner has a constantly
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE:
Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.
!
press
here
Vax U91-PF Series User Guide.qxd:U91-PF-B-T 18/3/09 10:53 Page 5
