---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
6
Operation
---
Operation
How to use on floors (Cont)
4
Vax Careline
0844 412 8455
H90-GA-B User Guide.qxd:User guide 30/10/09 14:16 Page 4
How to use on carpets?
7.
Pay attention to the water tank’s viewing window to monitor remaining water/steam. As the
water tank empties, a special water sensor will cause the unit to work intermittently and
eventually stop running in order to protect the pump inside the unit. A vibrating sound may be
heard, and the green/red indicator light will turn red. The pump will turn OFF.
WARNING:
Never leave the Steam Mop in one spot on any surface for an extended
-
period of time with a damp or wet microfiber cleaning pad attached as
this may damage the floor surface.
8.
Press the steam pump switch to the OFF (O) position. Unplug the Steam Mop.
9.
Refill the water tank using the water fill cup and funnel as previously described. (How To Use)
The indicator light will change to green. Continue steam cleaning.
10.When cleaning with the Steam Mop is completed, press the steam pump switch to OFF (O).
Unplug the unit from the electrical outlet.
11.Carefully remove the microfiber cleaning pad from the Steam Mop head.
CAUTION:
Cleaning pad and mop head may be hot.
IMPORTANT:
Do not store unit with a damp or wet microfiber cleaning pad attached.
Your Steam Mop is designed to clean carpets or rugs that will withstand high heat. Be sure
to check the Use and Care Instructions from the carpet manufacturer before steam cleaning.
WARNING:
The carpet glider accessory is for use on carpeting and rugs only. Use of the
-
carpet glider on other floor will cause streaking and possible scratching of
the floor’s surface.
IMPORTANT:
Never use the Steam Mop without the microfiber cleaning pad properly
attached to the mop head.
IMPORTANT:
Check the water tank viewing window to be sure there is adequate
water in the water tank.
For best results, thoroughly vacuum the carpets or rugs prior to steam cleaning.
1.
Place the mop head (with microfiber cleaning pad in place) on top of the carpet glider.
2.
Do not attempt to use the Steam Mop on carpet/rug surfaces without the carpet glider in place!
CAUTION:
Never use the carpet glider on surfaces that are prone to scratching.
CAUTION:
The Steam Mop emits steam and creates moisture.
If the Steam Mop operates too long in one place, water marks can result.
3.
Steam clean carpets or rugs using the detailed instructions outlined in the (How To Use
On Carpets) section.
