Dry pick-up
Disconnect Wet/Dry vac from electrical outlet.
With hose removed from cleaner, slide wet/dry
selector (A) to expose ‘dry tank inlet’ (B).(Fig.11) Selector
will snap into place. Insert hose into ‘dry tank inlet’.
Attach the desired tool to hose end.
Make sure cleaner lid is locked in place.
7
Use & Function
Adapter
To use 1
1
/
4
inch smaller diameter tools (not included)
with the 2
1
/
2
inch diameter hose, attach adapter (A) to
hose, then attach the tool to the adapter.
.
Twist adapter and tool to tighten or loosen.
Separate wet/dry tanks
This feature enables the user to change from wet
pick-up to dry pick-up without having to empty the
tank or change filters. Dry debris will collect in the inner
tank and wet debris will collect in the outer tank.
Wear ear protection if operating Wet/Dry vac for
a prolonged period of time.
Make sure that the small foam and cartridge
filters are in place.
A
A
B
C
A
Wet pick-up
Disconnect Wet/Dry vac from electrical outlet.
With hose removed from Wet/Dry vac, slide wet/dry
selector (A) to expose ‘wet tank inlet’ (C). (Fig.12)
Selector will snap into place. Insert hose into ‘wet tank
Fig.10
Fig.11
Fig.12
Vax VO-7000 D7 IL 10/19/04 3:35 PM Page 7
Attach desired tool (with squeegee if available) to hose
end.
Make sure cleaner lid is locked in place.
Do not use Wet/Dry vac as a pump to clean
out clogged drains, sinks or other plumbing
fixtures. If cleaner will not pick up, check filters.
They may need to be cleaned or replaced,
see ‘Maintenance’ section.
inlel
,
.
