Taking care of your machine
Taking care of your machine
WARNING: Always switch off and unplug the carpet washer from the mains before assembling, filling and emptying
the clean water tank, emptying the dirty water tank or before connecting/disconnecting the attachments.
WARNING: Always unplug the carpet washer before performing any maintenance/troubleshooting checks
All water and detergent must be removed from tanks.
IMPORTANT: If the hose or tools are blocked, switch off the carpet washer and remove the blockage(s) before
re-starting your machine.
Emptying the dirty water tank
Cleaning the base lint filter
Lift dirt water tank by
carry handle.
Empty dirty water over
the sink. Rinse dirty water
tank and lid under water to
remove debris.
Pull to remove dirty
water tank.
Clean the filter screen
located at the back of the
dirty water tank by scooping
out the debris.
Lift dirty water tank clip up
and outward to release.
Empty and rinse out clean and
dirty water tanks and leave to
air dry before replacing.
Do not leave detergent/
water stored in the tanks
between uses.
IMPORTANT
Cleaning the nozzle
Lie carpet washer on its
back. The filter is located
behind the brushes.
Leave to dry for 24 hours
or until fully dry before
placing back in the carpet
washer.
Pull filter to remove.
Rinse filter under water to
remove debris.
24
Remove dirty water tank.
Lift and pull top of nozzle
to remove.
Rinse nozzle under water
to remove debris.
Line up tabs on nozzle with
holes in carpet washer. Slide
tabs into holes, press down on
nozzle until clicks into place.
TIP
The lint filter should be
checked and cleaned after
every use, if blocked the
SpinScrub brushes may
not turn.
