Page 3 / 4
170926
FIG.4
(View from Bottom of Back plate)
(Exterior Wall)
TIME
SENSITIVITY
TEST
0
3 6
5. Manual Override MODE (nighttime operation only; on at dusk, off at dawn)
●
In 3, 6 or 0 mode, to shift to manual override mode, turn off the wall switch in 3 seconds and then turn it on again,
the light will turn to high-level brightness at dusk, and turn off automatically at dawn. To return to the previous
settings, turn off the wall switch in 3 seconds and then turn it on again. (See FIG.2)
● The lights will turn off automatically at dawn.
Note: You can adjust the low level brightness (0~50%) by using the slide switch on the side of back
plate.(See FIG.3)
Shut-off Delay
The Shut-off delay is the length of time the light will stay at high-
level brightness after motion has ceased to be detected. This
Shut-off delay can be set when operation is in 3, 6 or 0 Mode by
using the “TIME” knob located on the left side of the panel at the
bottom of the back plate (See FIG. 4) . To increase the shut-off
delay, turn the knob clockwise. To decrease shut off delay, turn
the knob counterclockwise. The delay may be adjusted from a minimum of 5 seconds to a maximum of 3 minutes. The
light will stay on as long as motion is detected continuously and will automatically turn to low-level brightness when no
more motion is detected after the delay time has passed.
Sensitivity of Motion Sensor
The sensitivity of the motion sensor can be adjusted by using the “SENSITIVITY” knob located on the right side of the
panel at the bottom of the back plate (See FIG.4). To increase sensitivity, turn the knob clockwise. To decrease
sensitivity, turn the knob counterclockwise. The sensitivity may be adjusted from a minimum of 5 feet to a maximum of
40 feet.
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. You may wish to
make adjustments when the season changes.
For best performance, gently clean the lens with a soft
cloth every 1 or 2 months to assure maximum sensitivity.
2. For best performance, install fixture at least 6 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 40 feet at 77 degrees
Fahrenheit. (See FIG.5)
3. The sensor detects across a detection range of 220 degrees.
(See FIG.6)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See FIG.7)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
CUSTOMIZATION OPTIONS:
5`
6`
10`
40`
FIG.5
Where you install your lantern is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
FIG.6
220'
Motion
Least sensitive
Motion
Most sensitive
Sensor
FIG.7
“3H Mode”
“6H Mode”
“0 Mode”
Manual
Override
Mode
Manual Override Operation Diagram
Turn wall switch OFF-ON
in 3 Seconds
FIG.2
Turn wall switch OFF-ON
in 3 Seconds again
FIG.3
(View from one side of Back plate)
(Adjustable low level)
