Page 3 / 5
180412
Function and Operation
Choose a mode by
sliding the switch on the bottom of the sensor.
(See Fig.5)
Note: When power is first applied, the light will turn on to 100% brightness. The sensor will take 15 seconds
to warm up.
TEST MODE (daytime and nighttime operation):
●
To shift to the “TEST” mode, slide switch to “TEST” position.
● The light turns to low-level brightness automatically. It turns to high-level brightness
when motion is detected, and stays on as long as the motion continues. Then
switches back to low-level brightness about 5 seconds after motion is no longer
detected.
Note: You can adjust the low-level (0~50%) and high-level (50~100%) brightness
by using the brightness switch on the back plate.
AUTO MODE (nighttime operation only):
● To shift to the “AUTO” mode, slide switch to “AUTO” position, and rotate Time knob
arrow to the desired time setting (between 5 seconds and 3 minutes). At dusk, the
light turns to low-level brightness automatically, it turns to high-level brightness when motion is detected, and
stays on as long as motion continues. When the motion is no longer detected, it remains on for the predetermined
shut-off delay time you set (5s ~ 3min), and then turns to low-level brightness.
● The light turns off automatically at dawn.
Note: You can adjust the low-level (0~50%) and high-level (50~100%) brightness
by using the brightness switch on the back plate.
SWITCH CONTROL MODE (daytime and nighttime operation):
Set in the Switch control mode, which is directly controlled by the power Switch to control the light or turn off the light,
It is decided by high level adjustment, low brightness cannot adjust.
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 4
1. Gently grasp the light heads and tilt them up or down, left or right to
adjust the light coverage area. Keep the light heads at least 1˝ (25mm)
away from the sensor.(See Fig. 4)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and
electrical shock.
Fig. 2
Fig. 3
Adjusting the Light Head:
Fig. 5
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side
of the bottom surface of the sensor. (See Fig. 4)
●
Adjust motion sensor sensitivity to achieve desired performance.
●
Approximate range for each setting from 5ft to 70ft.
25%
50%
100%
75%
50%
Test Auto
Timer
Sensitivity
5S
3Min
Low Level High Level
Switch
Control Custom
Setting
0
