11
Connect HDMI or SDI output port of the receiver to SDI or HDMI input
port of the HD monitor. Make sure all antennas and batteries are equipped
normally.
4. Operation instruction
■
Getting started
After finishing all steps above, system is workable, follow below
steps.
a) Ensure the video source output of the camera is OK, and the HD
monitor is power on and switched to connected video input port.
b) Ensure all input, output SDI or HDMI cables are connected.
c) Ensure all antennas are installed, and it is better to keep TX 2
antennas and RX 5 antennas with orthogonal angle each other for
best RF performance.
d) Ensure both the transmitter and receiver installed batteries or DC
input ports connected to outside power sources. Then toggle
power switch of transmitter and receiver to ‘ON’ respectively,
then ‘Power’ indicator will light.
e) Ensure the frequency knobs of transmitter and receiver are set
with the same number, and this will make sure the transmitter and
receiver work with same RF frequency.