15
Approached
This alert is displayed for 30 seconds, from the moment the Transmitter has been detected as out of range
Range Limit
until the
Out of Range
warning is displayed. The message is a warning that the video signal is about to be
lost.
This message appears only when OSD display is enabled.
Video Signal Not
A link has been established between the Transmitter and the Receiver, but no video signal has been
Detected
detected. This message appears regardless of whether OSD display is enabled.
System Messages – No Link
These system messages may appear when no live video is displayed:
Alert
Description
Searching for
This message is displayed until a link is established. This may occur when the Transmitter is out of range
Transmitter
or unavailable, or when the Receiver has been removed from its list of paired devices.
Pairing in Progress
This message is displayed while the Transmitter is pairing with a Receiver.
For a detailed description of the pairing process, refer to
Multicasting to Multiple Monitor Units
.
Multicasting to Multiple Receivers
A single Transmitter can transmit video downlink to up to 4 Receivers. This is called
multicasting
. The
following procedure describes how to pair an additional Receiver with the same Transmitter.
NOTE
1. The Transmitter and Receiver provided in the same box are preconfigured to
au-tomatically search for and connect to each other. Therefore, there is no
need to perform this procedure on the Transmitter / Receiver delivered in the
same box.
2. Register one Receiver at a time to each Transmitter.
Pairing Additional Receivers with a Transmitter
To pair an additional Receiver with a Transmitter:
1. Set up the additional Receiver, as described in
Setting Up the Thor 800FT+ Receiver
. The
Receiver must be placed between one and ten meters from the Transmitter. To enable optimal
reception, each Receiver must be placed at least a few meters away from other Receivers.
After setting up the additional Receiver, the following message is displayed on the monitor
connected to the Receiver’s SDI or HDMI port:
"Receiver not registered to Transmitter."
2. From the Receiver, activate the OSD display. Navigate to the
Pairing
menu, and select
Start Pairing
.
