BAG MARKED
STEP18-20
19
Rear Suspension Arm Assembly Part2
14
© VBC Racing WILDFIRE D06
Rear Suspension Upright A-03-VBC-0037 x 2
Shaft End Shoe A-03-VBC-0038 x 2
Inner Axle B-02-VBC-0024 x 2
Wheel Axle B-02-VBC-0025 x 2
Axle Joint B-02-VBC-0026 x 2
Axle Lock Spring B-02-VBC-0027 x 2
5x10mm Ball Bearings
C-02-BB-1005-P x 4
M2x12 Shaft Pin B-02-VBC-3035 x 2
M2x10 Shaft Pin B-02-VBC-0020 x 4
M3x10 Set Screw C-02-SC-SS-0310 x 2
M3x2 Set Screw C-02-SC-SS-0302 x 2
M1.6x4 Screw C-02-SC-R1.6x4 x 2
0 Offset Hex Wheel Hub B-02-VBC-0051 x 2
Ball Connetor (7.5mm Lenght)
B-02-VBC-3022 x 2
Grease
Grease
Grease
Thead Lock
Thead Lock
After assembling the drive shaft, make sure the joints are free swinging.
Align the Shaft End Shoe to the Inner Axle Pin
hole first and slide the 12mm Shaft Pin to the
pin hole before securing the pin with M3x2 Set Screw
Align the Shaft End Shoe to the Inner Axle Pin
hole first and slide the 12mm Shaft Pin to the
pin hole before securing the pin with M3x2 Set Screw
Do not over tighten the M1.6x4 screw to prevent stripping
T2 7075 Spacer B-02-VBC-0019-20 x 2
Rear Suspension Upright
Rear Suspension Upright
Shaft End Shoe
Shaft End Shoe
M2x12 Shaft Pin
M2x12 Shaft Pin
Inner Axle
Inner Axle
Wheel Axle
Wheel Axle
Axle Joint
Axle Joint
Axle Lock Spring
Axle Lock Spring
M2x10 Shaft Pin
M2x10 Shaft Pin
5x10mm Ball Bearings
5x10mm Ball Bearings
5x10mm Ball Bearings
5x10mm Ball Bearings
M2x10 Shaft Pin
M3x2 Set Screw
M3x2 Set Screw
M1.6x4 Screw
0 Offset Hex Wheel Hub
Ball Connetor
(7.5mm Lenght)
Ball Connetor
T2 7075 Spacer
T1 7075 Spacer
Axle Lock Spring
Wheel Axle
Make sure the Axle Lock Spring is place correctly onto the Wheel Axle
Joint cross section
Grease
Note The Lock
Slot Direction
Note The Lock
Slot Direction
Optional :
Shaft End Shoe (Self Lubricating)
A-03-VBC-0077
