2
Fitting the contact box
1. Fit an appropriate bracket on the vehicle. Locate the
control box horizontally and so that nothing prevents
the socket from disconnecting automatically.
2. Slip the conduit entries onto the cable - sealed nut
- washer - gasket.
3. If both conduit entries are not to be used, fit a plug
with washer and gasket.
4. Lock the cover in the open position.
5. Remove the insert and pull each cable through its
respective entry point. Pull it out as much as necessary
to work comfortably with the connections.
6. Strip the cable casing back about 60 mm.
7. Check and label the wires by function.
8. Strip the wires about 5 mm. Fit cable shoes with the
recommended dimensions.
9. Connect the cables to the flat connector blades in
the insert as per the wiring plan. Spray with VBG
Electro Oil onto the cable shoes and connector blades
to prevent corrosion.
10. Place the insert in the box and affix it using two
screws.
N.B. The upper edge of the insert shall be located inside
the support heel in the upper edge of the box (10b).
Close the cover.
11. Adjust the cable at each conduit entry point without
exerting pressure on the cable.
12. Insert and tighten the conduit entry with moderate
force so that it seals.
13. Tighten the contact box in the brackets with three
screws, lock washers and nuts. The contact box shall
be seated horizontally and with the label upwards.
This is important so that the socket can disconnect
automatically.
• Fit the electrical heating coil (where applicable)
between the parking light and earth in the contact box.
• Terminals 1 and 12 require larger cable shoes (9.5
mm). The cable dimension shall always be chosen
taking power consumption into consideration. When
dimensioning, keep in mind any extra equipment that
may be fitted at a later date.
b
Strip 5 mm
1,5 mm
1 Earth
Earth
Earth
2 A L Flashers
A L Flashers
A L Flashers B Aux
3 A R Flashers
A R Flashers
A R Flashers B Aux
4 A Brake Lights
A Brake Lights
A Brake Lights B Aux
5 A L Tail Lights
A L Tail Lights
A L Tail Lights B Aux
6 A R Tail Lights
A R Tail Lights B Aux
A R Tail Lights B Aux
7 A Reversing B Fog Light
A Reversing B Fog Light
A Reversing B Fog Light
8 A Aux
B Aux
A Aux
A Aux
B Aux
9 A Aux
A Aux
B Aux
A Aux
B Aux
10 A Aux
A Aux
B Aux
A Aux
B Aux
11 A Aux
A Aux
B Aux
A Aux
B Aux
12 Charging Current
Charging Current
Charging Current
Wiring plan
Ter. 14-terminal (black ) 17-terminal (red) 22-terminal (green)
