Outputs: Analogue Setup Menu (Channel 1 and 2)
OUTPUT
Press ’■’ and then use the ‘◄’ and ‘►’ buttons to associate either of the following channels SPEED,
SLIP or PITCH, ROLL, LAT ACC and LONG ACC to the Analogue output. Then press ’■’ to confirm.
VALUE
@ +5V
Press ’■’ and then use the ‘◄’ and ‘►’ buttons to set the value to rep5 V. Then press ’■’ to
confirm.
1 – 400 km/h (1 km/h steps)
–179
o
to 180
o
(0.1
o
steps) for Slip
-89
o
to 90
o
(1
o
steps) for Pitch
-89
o
to 90
o
(1
o
steps) for Roll
-1 to 2 g (0.1g steps) LAT ACC
-1 to 2 g (0.1g steps) LONG ACC
VALUE
@ 0V
Only available when output is set to SPEED.
Press ’■’ and then use the ‘◄’ and ‘►’ buttons to set the velocity to represent 0 V. Then press ’■’ to
confirm.
0-399 km/h (1 km/h steps)
VALUE
@ -5V
Only available when output is set to LAT ACC, LONG ACC, PITCH, SLIP or ROLL.
Press ’■’ and then use the ‘◄’ and ‘►’ buttons to set the value to represent -5 V. Then press ’■’ to
confirm.
-2 to 1 g (0.1g steps) LAT ACC
-2 to 1 g (0.1g steps) LONG ACC
–180
o
to 179
o
(0.1
o
steps) for SLIP
-90
o
to 89
o
(1
o
steps) for PITCH
-90
o
to 89
o
(1
o
steps) for ROLL
TEST
Press ’■’ and then use the ‘◄’ and ‘►’ buttons to set a test value that the Analogue output will simulate.
Then press ’■’ to quit.
9
