Issue 10/2019
©
Continental Automotive
101
Attention
The VDO paper should always be replaced when the red
stripe on the back of the print, is shown. Any vehicle must have
an extra paper roll available in the inspection. This is also
subject to assessment.
Attention
When checking dust accumulation at the printer, or
misalignment in printout, please go to a VDO workshop to
perform printer maintenance.
Attention
In the event of vibration, the unwinding coil may occur inside
the printer making printing difficult, it is recommended to
remove the coil and manually wind it up by re-inserting it into
the printer.
2.4.15 Information in printing - standard application
As the standard printing of the BVDR has a lot of information, they are divided
between header, footer and vehicle operation. This information also depends
necessarily, according to current law, of correct identification done by the
vehicle driver. In figure below full standard printing can be seen.
