102
©
Continental Automotive
Issue 10/2019
2.4.15.1 Diagram tape header
The Diagram tape header and its information are according to next figure:
Standard information: it is the information that, independent of vehicle or
installation model, will always be the same.
a.
Manufacturer: standard information.
b.
Tachograph model: standard information.
c.
Serial number: 8-digit sequence indicating the number of BVDR
manufacturing series.
d.
Vehicle plate: number of the vehicle plate in which the BVDR is installed.
e.
Chassis: number of the car chassis in which the BVDR is installed.
f.
K constant of speed: it is the characteristic factor of the vehicle, which is
used to calculate the speed and distance covered by it.
g.
Report start: vehicle information when it started its operation, and these
are the odometer value, date and time.
h.
Report end: vehicle information when printing was requested, and these
are the odometer value, date and time.
i.
Traveled distance: distance traveled in the last 24 hours of the vehicle for
all its drivers.
j.
Driver ID: the identification is nothing more than the record of the national
driver's license. Thus, in the inspection, the driver must present its driver's
license and information should be the same. In figure above the driver
(3) was the last to be identified and have led the vehicle in the last 24
hours and the driver
(1) was the first to be identified and have led the
vehicle in the past 24 hours.
