Issue 02/2017
©
Continental Automotive
29
Attention
To ensure smooth operation of the printing device, it is
important not to have an ignition event during this procedure.
In the data report print cases the last 24 hours in ribbon
diagram (standard application) should be made only on pre-
printed paper VDO and in the case of printing the last 5 min
(application Chile) should be made on paper white VDO,
ensuring the correct printer operation.
2.4.8
Data upload using USB
a) This function allows the operator to start the data recording process on the
USB drive. The operator selects the menu shown below.
b) When the "OK" button is pressed, the operator must select the desired option
to extract the data.
c) During the data recording to the USB drive, the following message appears
until the end of the recording, as follows.
d) At the end of the recording, the success message is displayed:
BVDR might not recognize some kind of USB
Sticks or defective USB Sticks. In case of this
occurrence remove the USB Stick, turn Ignition Off
for 10 seconds, and then turn the Ignition ON again.
If the issue persists please change the USB Stick to
another one in good use conditions.
Summary of Contents for BVDR
Page 1: ...Digital BVDR Tachograph Operator s Instruction manual...
Page 54: ......
