Issue 02/2017
©
Continental Automotive
37
Attention
The VDO paper should always be replaced when the
red stripe on the back of the print, is shown. Any
vehicle must have an extra paper roll available in the
inspection. This is also subject to assessment.
Attention
When checking dust accumulation at the printer, or
misalignment in printout please, go to a VDO
workshop to perform printer maintenance.
Attention
In the event of vibration, the unwinding coil may occur
inside the printer making printing difficult, it is
recommended to remove the coil and manually wind it
up by re-inserting it into the printer
2.4.14 Information in printing - Standard Application.
As the standard printing of the digital tachograph has a lot of information, they
are divided between header, footer and vehicle operation. This information also
depends necessarily, according to current law, of correct identification by the
vehicle driver. In figure 2.5.2.1 full standard printing can be seen.
Figure 2.5.2.1
Summary of Contents for BVDR
Page 1: ...Digital BVDR Tachograph Operator s Instruction manual...
Page 54: ......
