DLKPro Download Key • Operating Instructions – Edition 03/2012
4 Downloading data
Downloading a driver card using the integrated chip card reader
Using the integrated chip card reader, you can transfer
the data of a driver card straight to the DLKPro
Activating the chip card reader
Insert the licence card into the integrated chip card
reader with the chip facing upwards and the arrow
pointing in the direction of the reader.
A message is displayed indicating that the licence
has been activated.
Remove the licence card.
Write down the serial number of the DLKPro on the
licence card. The serial number is at the back of the
DLKPro on the model plate.
You can then use the integrated chip card reader for
downloading driver cards.
Downloading driver card data
Insert the driver card into the integrated chip card
reader with the chip facing upwards and the arrow
pointing in the direction of the reader.
Card download starts automatically.
A progress bar shows how the download is
progressing.
When the download has finished, the LED on the
DLKPro remains green and beeps indicate that the
download was successful.
When data transfer has finished, remove the driver
card.
You can then view the downloaded data either on the
screen or using the “DownloadTools” PC programme;
see pages 11 and 21.
Notes
:
• Activate the integrated chip card reader if you want
to transfer the card data directly to the DLKPro.
• Before the first card download, connect the DLKPro
to the digital tachograph and carry out a mass
memory download.
• Please remember to charge the battery for the card
download.
Note
: Card download is not possible if the DLKPro is
plugged into the computer.
Note
: You can also use the integrated chip card reader
to download data from company cards, control cards
and workshop cards.
Note
: The licence card for activating the integrated chip
card reader can be obtained from your service partner.
Note
: If the download was not successful, the LED on
the DLKPro flashes red and intermittent beeps can be
heard.
• In this case, check whether or not the DLKPro has
enough memory available; see page 13.
• Try the download again, e.g. using the digital
tachograph.
If the download fails a second time, use the
PC programme to collect the support files and
contact your service partner; see page 31.
