VDO DOM 6500, Installation And Owner'S Manual

Taking safety precautions, Fig. 1

A

Before starting work, disconnect the earth cable from the vehicle battery’s negative terminal

in order to prevent short circuits. For this purpose, follow the vehicle manufacturer’s safety
instructions (alarm system, airbag, immobiliser, etc.).

Electrical connections, Fig. 2

☞

Route all cables with care. For the cabling, refer to the connection illustration on the
cover pages and the following table.

☞

Do not cut off non-assigned cables. Instead, wrap them up and fix them to one side. They
may be necessary for retrofitting additional functions.

Power supply connection

Cable colour

Category

Connection

Yellow

Input

+ 12 V permanent positive (must be rated for a current of at least 3 amps)

Red

Input

+ 12 V ignition positive (switched plus)

Black

Input

Battery negative (vehicle chassis)

Blue

Output

+ 12 V remote control output (max. 0.25 A)

White

Input

Door contact/interior lighting (must be rated for at least 1 A)

A

Only connect electrical signals to suitable connecting points in the vehicle.

A

A If the 12 V permanent positive lead is extended and connected directly to the

battery, it must be additionally protected by means of a 10 A fuse near the battery (max. 10 -
15 cm).

■

12 V permanent positive (yellow):

☞

Connect yellow lead to a suitable connector with 12 V permanent positive.

A

This connection should be rated for a current of at least 3 amps.

■

12 V ignition positive (red):

☞

Connect red lead to a suitable 12 V circuit switched through the ignition.

■

Battery negative (black):

☞

Connect black lead to a suitable ground (vehicle chassis).

■

12 V remote control output (blue):

☞

Connect the blue lead to the remote control output for additional devices (e.g.
multimedia interface box).

■

Interior lighting (white):

The DOM 6500 has two built-in lamps that can be connected to the interior lighting system
of the vehicle.

☞

Connect the white lead to a suitable connector for the interior lighting.

Audio/video inputs “AV1 IN” and “AV2 IN”

☞

Connect the rectangular Mitsumi plug to the video input “AV1 IN” of the multimedia
system (in the recess on the top of the unit).

☞

Connect the 4-pin jack of the supplied A/V cable to video input “AV2 IN” on the right side
of the multimedia system.

INSTALLATION INSTRUCTIONS

10