4. Operational mode
Setting activities
© Continental Automotive GmbH
35
4
쮿
Setting activities
왘
Manual setting
Setting activitiy
1.
Driver 1
presses the button
,
The standard display
(a)
appears.
2.
Continue pressing the button until the
desired activity (
) appears in the
display
(1)
. After aprox. 5 seconds, the
previous display appears.
3.
Driver
2
presses the button
.
왘
Automatic setting
The DTCO 1381 switches automatically to
the following activities:
왘
Automatic setting after ignition
on/off *
After ignition on/off, the DTCO 1381 can be
configured to switch to a defined activity; for
example "
".
The activity
(1)
and/or
(2)
which changes
automatically on the basis of ignition on or
off, appears in the standard display
(a)
and
flashes for approx. 5 seconds. Then, the
previous display will appear again.
Flashing of the activity(ies) in the standard
display (a)
= Driving time (automatic when driving)
= Other work time
= Availability (waiting time, co-driver
time, driver 2 sleeper-cab time during
a journey)
= Break times and rest periods
The activities may be set only if the
vehicle is stationary!
Driver 1
1
Driver 2
for ...
Driver 1
Driver 2
Driving
Vehicle stop
At the end of a shift or at the start
of a break,
always
set the activity
to "
". This will ensure that the
VDO Counter * provides an
accurate calculation.
As necessary, change the set
activity according to your current
task.
18:01
0km/h
123456.7km
1
2
Service
only
Summary of Contents for DTCO 1381
