6. Menu functions
Main menu entry vehicle
© Continental Automotive GmbH
61
6
쮿
Main menu entry vehicle
You can perform the following entries in
this main menu.
왘
Enter Out beginning / end
If you use the vehicle for a journey outside
of the scope of the regulations, you can set
the function to "Out of Scope" and/or end
it again.
Select the following functions step by step.
The setting "Out of Scope" ends automat-
ically as soon as you insert a driver card
into card slot 1 or withdraw a driver card
from slot.
왘
Enter Beginning of ferry / train
Select the ferry / train specific condition,
when you are about to drive on to the ferry
/ train or when you have just parked up on
the ferry / train.
Select the following functions step by step.
3.
Then set your current activity using
key
.
The recording of the port operation is auto-
matically ended as soon as a one-minute
driving period has been recorded by the
DTCO 1381.
왘
Set Local time
Select the listed functions step by step.
In the standard display, you may adjust the
time to the local time zone as well as to the
beginning or end of daylight-savings time
in steps of ±30 minutes.
1.
2.
entry
vehicle
vehicle
OUT end
vehicle
OUT
begin
1.
2.
The "
" symbol is no longer dis-
played when the vehicle is moving.
The display is shown again however
when the vehicle stops before one
minute of driving time is recorded by
the DTCO 1381.
entry
vehicle
vehicle
ferry/train
Read and understand the chapter
"Time management" before
attempting to make any changes!
1.
2.
3.
entry
vehicle
vehicle
local time
UTC
29.03.2013
23:32
00:32
UTC
29.03.2013
23:32
00:02
UTC
27.03.2013
23:32
23:32
Service
only
Summary of Contents for DTCO 1381
