When the equipment is first put into operation, it is important for an antenna to be
connected to the DTV 6500 and that the vehicle is parked in a location where DVB-T
reception is possible. If necessary, enquire in advance via conventional media or the
internet whether DVB-T is available in your area.
☞
Switch on the ignition.
:
The “Welcome!” screen with the DVB logo appears briefly.
Thereafter you should carry out the following steps to install:
■
“Country Setup” - to set the OSD language
☞
Press the
4
or
6
key to set the
required language for the menu.
☞
Press the
OK
button to go to the
next step of the install procedure.
■
TV Format
☞
Press the
4
or
6
key to set the desired TV format.
☞
Select “4:3” (Letterbox) or “16:9” depending on the monitor you have connected.
☞
Press the
OK
button to go to the next step of the installation procedure.
■
Automatic Channel Search
Once a TV format the equipment automatically searches through the entire reception
range of the DVB-T tuner for programmes that it can receive.
☞
Please note that full installation is only possible when a DVB-T signal is available.
:
The progress of the channel search and the number of channels located is displayed
on the screen.
:
When the search has completed successfully, the equipment tunes in to the first
program on the automatically generated list.
✎
If the channel search fails to locate any channels, a message to that effect is
displayed.
☞
In this event, press the
OK
button to open the antenna installation menu.
Initial operation
10
Country Setup
Language
English
