IMPORTANT INFORMATION
A
The system must only be installed by trained personnel.
A
Observe automotive industry quality standards.
A
Fire hazard. When drilling, take care not to damage concealed wiring harnesses, the fuel
tank or fuel lines.
A
Never drill into supporting or safety-relevant body parts.
It is essential to observe the following when installing components in the passenger
compartment:
A
Ensure that the driver has a clear all-round view.
A
Increased risk of injury in the event of an accident. Do not install components in the
inflation range of the airbag or in areas where the head or knees may knock against them.
A
Only install the unit in vehicles with a 12-V or 24-V on-board voltage and negative pole
on the vehicle body. Risk of malfunctions, damage and vehicle fire if installed in unsuitable
vehicles.
A
Do not damage safety system wiring (airbag etc.). (Wiring is normally specially marked,
e.g. by labels.)
A
Do not use test lamps to test the voltage, since excessively high currents can damage /
destroy electronic components.
A
Do not use any pinch or cut connectors. Solder all wiring connections. Insulate all solder
points with shrink hose or insulating tape.
A
Fit toothed washers at earth connections to the vehicle body. If necessary, remove paint
and dirt beforehand. Subsequently, protect bare metal against corrosion.
A
In order to ensure perfect installation, use only the original components supplied. The
use of non-authorised components may result in malfunction.
A
Do not install the unit in positions where it is exposed to high temperatures, dust, dirt or
excessive vibration (e.g. due to direct sunlight or heating vents).
Installation
5
English
