IMPORTANT INFORMATION
A
Only trained specialists may install the unit.
A
Observe the automotive industry quality standards.
A
Fire hazard! When drilling, care must be taken not to damage hidden cable harnesses,
the fuel tank and fuel lines.
A
Never drill into supporting or safety-relevant chassis parts.
A
Install only in vehicles with 12 V on-board voltage and negative earth to the body. Risk
of malfunction, damage and vehicle fire if installed in unsuitable vehicles (e. g. heavy goods
vehicles, busses).
Connection in vehicles equipped with standard ISO
connectors
The navigation radio may be installed without major preparation in vehicles equipped
with ISO standard connectors. Some signals may have to be connected to ISO connec-
tor A (refer to “Connection overview ISO chamber A”).
For vehicles with different connection requirements, ask your dealer for special cables
for a problem-free installation (refer to the attached overview of connector cables).
Connection in vehicles without standard ISO connectors
If no adapter cables are available for your vehicle, connect the navigation radio as
described in “Electrical connections”.
Taking safety precautions, Fig. 1
A
Before starting work, disconnect the earth cable from the vehicle battery’s negative
terminal in order to prevent short circuits. For this purpose, follow the vehicle manufact-
urer’s safety instructions (alarm system, airbag, immobiliser, etc.).
Make electrical connections
Route all cables with care. For the cabling, refer to the connection illustration on the
cover pages and the following table.
Do not cut off non-assigned cables. Instead, wrap them up and fix them to one side.
They may be necessary for retrofitting additional functions.
INSTALLATION INSTRUCTIONS
9
English
