Screen configuration
Here different colour combinations can be selected for the screen display,
and the status line can also be configured:
•
“Day colour”: This setting is active if the headlights are switched off.
Optimum contrast in daylight is provided by blue, red and green.
•
“Night colour”: is active with the headlights switched on. Optimum
legibility at night is provided by dark blue, dark red and dark green.
•
“Status line left”, “Status line right” or “Status line top”: For display of
information in the respective lower corners or in the centre at the top
of the screen:
None
Display of the current time
Date
Remaining travel time: The calculated remaining time until arrival
at the next via point or destination.
Remaining dynamic travel time (including delays due to stationary
traffic)
Estimated time of arrival: Calculated time of arrival at the next via
point or destination.
Estimated dynamic arrival time (including delays due to stationary
traffic)
Entire delay on route
Distance to next via point or destination
Geographical elevations, elevation above sea level To use this
function the system must be receiving signals from at least 4
satellites.
Current speed
TMC
Speed limit. It should be pointed out here that the speed limits
issued by the navigation system are not always current. It is
imperative that the currently applicable speed limit be observed.
•
“Map colour”: allows day/night colours to be selected.
One value can be selected for display:
u
Select “Screen config.” in the “Settings” menu. Press the OK key.
u
Select the function to be set. Press the OK key.
u
Select your option and press the OK key. The cursor will
automatically move to the previous menu.
18
GENERAL INFORMATION
