✎
The mobile phone can only be operated directly from the phone once the ignition has
been switched off. To operate it via the monitor and remote control, the ignition
must be switched on.
✎
Some options are available only with selected mobile phones. You can find an up-
to-date compatibility list on the internet at www.vdodayton.com.
Calling
Volume of call
During the telephone call:
☞
Press the
V
button once or several times to increase the volume.
☞
Press the
W
button once or several times to decrease the volume.
✎
The last setting selected is stored. Alternatively, the volume can be adjusted on the
mobile phone itself.
✎
The ring volume for an incoming call can be lowered or increased. Alternatively, the
volume can be adjusted on the mobile phone itself.
✎
During a telephone call, it is only possible to set the volume of the navigation mes-
sages via the “Settings –> General settings –> Audible settings” menu.
Dialling
The following options are available for dialling a telephone number:
❑
Direct input using the number pad in the Phone menu.
❑
Transfer from one of the loaded phone books (SIM card, telephone memory).
❑
Transfer from one of the call registers (“Missed calls”, “Incoming calls” or “Outgoing
calls”).
❑
Direct dialling from the “Navigation” menu (phone number of the destination, if
entered).
❑
Direct dialling from the result list of the search engine for travel info, if a phone
number is specified. Also see “Travel info”, Page 47.
Direct input using the number pad
☞
Enter the desired phone number in the “Telephone” menu via the virtual number
pad.
✎
Once a digit has been highlighted with the cursor and the
OK
button has been pressed
to confirm the selection, the digit will be shown in the right-hand display field.
☞
After completing the input of the desired phone number, select the green handset
button
H
and confirm with the
OK
button.
:
The connection is established.
:
End the connection with the red handset button
P
.
Telephone
30
