32
Initial Setup
Before you can switch on the navigation
system for the first time, you must insert
the data medium containing map data
and connect the battery. This can be done
by performing the following steps:
•
Insert the memory card into the ap-
propriate memory card slot located on
the left of the device.
•
Open the battery compartment.
•
Plug the battery connector into the
battery socket as you can see on the
picture. Be sure to have the connector
in right orientation. Slide the battery
into the battery compartment and
place the cable into the small groove
above. Now you can close the battery
compartment.
•
Connect the navigation system using
the cigarette lighter cable to the
12V/24V power supply in your vehicle. The battery will then start to charge. It takes ap-
proximately 5 hours to fully charge the battery. The battery life without an external
power source is approx. 3 hours depending on application and adjusted display bright-
ness.
Assembly and Mounting
To mount the device in the vehicle, proceed as follows:
•
Find a suitable place in the vehicle for mounting the mount.
The screen be must be clearly visible from the driver's seat
but the device should not obscure the driver's view.
•
Position the mounting plate (passive cradle) on the mount-
ing in such a way that the dogs on the mounting locate in
the two recesses on the rear side of the plate. Then move
the locking plate to the side until it engages.
•
Please note the safety instructions when choosing the loca-
tion page 26.
•
Press the suction cup against the glass in a free sky viewing
position and move the pressure lever towards the glass un-
til it locks into place.
•
Attach the navigation system to the cradle.
On no account should the screen be adjusted by moving the device itself.
Dismounting:
To detach the device, switch the pressure lever in the opposite direc-
tion and carefully pull the transparent rubber end of the suction cup to remove it from
the window.
Setup and Mounting
QSG-ADD.book Seite 32 Mittwoch, 9. Mai 2007 1:13 13
