31
INSTALLATION
Installing the VDO Ocean Line Wind
Please read the safety instructions on pages 25 and 26
before starting the installation.
Installing the indicating instrument
-
Make a hole, diameter 86 mm, at an adequate location.
-
Clean the surroundings and remove the chips before inserting the
indicating instrument.
-
Pass the cable connections to the indicating instrument through
the mounting hole and the union nut.
-
Place the supplied black rubber washer on the instrument back
-
Connect the cables per wiring schematic to the indicating
instrument and insert the instrument into the mounting hole
(see Electrical installation).
-
Fix the instrument with the union nut.
Mounting alternative A for wall thicknesses
d = 0.5 mm to 6.5 mm
Mounting alternative B for wall thicknesses
d = 6.5 mm to 16.5 mm
-
Check that the union nut is only tightened hand-tight.
Mount the indicating instrument with threaded studs and
bracket (see page 32, top) if strong vibration must be
expected at the location of the installation (for instance high-
speed boats).
or
A
B
d
olwind_e.qxd 21.06.99 13:35 Seite 31
Summary of Contents for WIND
Page 2: ...Installation and Operating Instructions Page 22 40 21...
Page 3: ...22...
