VDO X1DW, Instruction Manual

X1DW 

VDO CYCLECOMPUTING

14

GB

SLO

PL

JP

JP

PL

SLO

GB

www.vdocyclecomputing.com  

 X1DW

15

Attention: The factory settings for bike 1 = 2155 
mm and for bike 2 = 2000 mm. If you do not enter 
any wheel sizes, the computer works with these 
factory settings. The values measured in this 
way for speed, distance etc. can differ widely 
from the actual values.

BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using 

. 

Confirm the entry with 

M

.

BIKE 1/SET OK? Confirm with 

M

.

The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.

How to set the clock:

Using     go to SETTINGS/ 
SELECT. Confirm with 

M

.

You are now in setting mode 
(pressing 

C

 for 3 seconds gets 

you back to function mode)

Using     go to CLOCK/SET. 
Confirm with 

M

.

CLOCK/24-H-MODE (you can 
switch to 12-H mode using    . 
Confirm with 

M

.

CLOCK...SET HOUR/CONTINUE
Set the hours using    .
Confirm the hour setting 
with 

M

.

CLOCK...SET MINUTES/ 
CONTINUE. Set the minutes 
using    . Confirm the  
minutes setting with 

M

.

CLOCK/SET OK? Confirm with 

M

.

The display confirms: CLOCK/SET DONE.
Automatic return to SETTINGS/SELECT.

5.3  Setting the clock 

You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).

Using     go to SETTINGS/
SELECT. Confirm with 

M

. 

You are now in setting mode 
(pressing 

C

 for 3 seconds gets 

you back to function mode).

Using 

 go to ODOMETER/

SET. Confirm with 

M

.

5.4  Setting the total kilometres

ODOMETER/ODO BIKE 1 
(use     to go to setting for 
BIKE 2). Confirm with 

M

.

ODO BIKE 1 ...SET DISTANCE/
CONTINUE.

You can set the flashing digits 
using     . To access the next 
digit, confirm with 

M

. 

Repeat the steps until the last 
digit on the right is flashing. 
Confirm with 

M

.

ODO BIKE 1/SET OK? Confirm with 

M

.

The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.

5.5  Switch from bike 1 to bike 2   

>>> P03

The selected Bike 1 or 2 is shown 
on the display bottom left (

).

Note: The transmitter on bike 2 must have been 
set to bike 2 before using it the first time. 

>>> P03

Your VDO computer can be used on 2 bikes. 
If you switch from bike 1 to bike 2, the 

computer 

recognises

 the transmitter from bike 2. The 

computer then 

automatically

 switches to bike 2.

All data are now saved for bike 2. When you use 
the computer again on bike 1, transmitter 1 is 
recognised. The computer switches to bike 1. 
The data are now saved for bike 1.