VDO X3DW Instruction Manual Download

Page: 215 / 364

X3DW

VDO CYCLECOMPUTING

SLO

www.vdocyclecomputing.com

X3DW

To wake it up out of despatch mode, press the

button simultaneously for a few seconds.

The computer is now ready for use and tells you
so by showing the language setting.

See also Chapter 4.4

4.2 Switching on the computer for the first time

>>> P02, Display see Chapter 4.4

Waking up from despatch mode

The computer is delivered with a battery installed.
To reduce the battery consumption, the computer
is put into despatch mode. The display is empty
(no display).

4.3 Installing the battery in the computer

>>> P05

4.4 Language setting after battery change

Your VDO computer is supplied with a 3V battery
(type 2032).

The battery is already installed when supplied.

To change the battery, proceed as follows:

After inserting the battery, your VDO computer
automatically welcomes you in the English main
menu.

LANGUAGE ENGLISH.
Confirm with

ENGLISH SELECT OK? Confirm with

step 1

Place the battery in the computer casing

with the +terminal facing up.

step 2

Make sure that the battery does not

get wedged.

Computer confirms:
LANGUAGE SELECT DONE.

Automatic return to SETTINGS/SELECT.
You are now in function mode. If you do not want
to make any more settings, you can recall the
functions using . If you want to make further
settings, confirm SETTINGS/SELECT with

When the battery is changed, all settings and the
total kilometres cycled are saved.

Depending on the room available, the transmitter
can be fitted at the front on the forks, inner side
of the fork or backside of the forks.

>>> P04

step 2

Place spoke magnet around an outer

spoke. The silver middle of the magnet points
towards the transmitter. Align the magnet to the
sensor mark on the transmitter with a gap
of about 1 – 5 mm.

step 3

Align transmitter and magnet for good and

fasten in place: Pull cable ties tight and push
magnet in firmly.

step 4

Decide whether fitting to handlebar or

stem and turn the base of the handlebar holder

by 90° accordingly. To do so, undo the screws in
the holder, take out the foot and turn it 90°, insert
and tighten the screws again.

ATTENTION: Do not over tighten screws.

step 5

Guide the cable ties through the slot in the

handlebar holder, place around the handlebars
or the stem and pull (do not pull tight just yet).

step 6

If fitting to handlebar: Align computer

angle to achieve optimum readability. Now pull
cable ties tight. Snip off protruding ends with
clippers.

step 3

Take care that the rubber seal lies flat on

the battery compartment lid.

step 4

Insert the battery compartment lid into the

opening and turn it with a coin to the right as far
as it will go (approx. 1/3 turn).

TIP for changing battery: VDO recommends
changing the battery once a year. Buy a new
battery in good time to ensure the wireless
transmission works perfectly. When the battery
is changed, all settings and the total kilometres
cycled are saved.

4.5 Placing the computer into the handlebar holder

>>> P06

The VDO twist-click system fastens the computer
securely with the handlebar holder.

step 1

Place computer into the holder in 10 o‘clock

position.

step 2

Twist computer to the right to 12 o‘clock

position and click into the holder system.

step 3

To take the computer out, twist to the left

(do not push or pull).