LVP603 series User Manual
www.videowall.cn
7
VGA signals, so as to make VGA picture clean and complete.
In general, this operation is made only when new VGA signal source is to
be connected in. Sometimes user need repetitively do such adjustment till
VGA picture looks clean, complete and stable.
3) Select output brightness
Button names
Description
BRT -
Decrease output image brightness of
LVP603,
the lowest brightness is 0.
BRT +
Increase output image brightness of
LVP603,
the highest brightness is 64.
LVP603 supports 32 levels Brightness, “0” represents the lowest brightness,
and 64 represents the highest brightness. To ensure full gray level of output
image, normally the output brightness is set as 64!
4) Information display (Info)
This button can be operated to display the following two status
information:
Current settings of LVP603:
press “Info” button to display current settings
and information of
LVP603
. There are total 29 items of information. Press
“Info” button again before the information disappears in LCD, the next entry
of information will appear in LCD.
Status of current input signal source:
press current input selection
button, then press “Info” immediately, the input signal source selected, e.g.:
“In: HDMI”, will appear in line 1 in LCD, and the status of current input signal
source will appear in line 2 in LCD. If no valid signal is input, “No Input” will
appear in LCD; if the signal is valid, its input signal format such as
“
1080p_60Hz
” will appear in LCD.
5) Select Cut / Fide mode
LVP603 can realize seamless or fading in/out switching effects, i.e.: Cut,
Fade, between the signals coming from the following 3 groups. But if the
signals come from the same group, LVP603 can only realize freezing
seamless switching effect.
