30
Getting to Know Your ABP-2000
31
Getting to Know Your ABP-2000
©Vecow ABP-2000 Series Advanced Box PC User Manual
2.5 Main Board Jumper Setting
The figure below is the top view of the ABP-2000 series
main board. It shows the location of the jumpers.
You may configure your card to match the needs of
your application by setting jumpers. A jumper is a metal
bridge used to close an electric circuit.
It consists of two metal pins and a small metal clip (often
protected by a plastic cover) that slides over the pins to
connect them.
To “close” a jumper, you connect the pins with the clip.
To “open” a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2 and 3. In this
case you would connect either pins 1 and 2, or 2 and 3.
2.4.8 GPS Module
The ABP-2000 series offers a u-blox NEO-7 GPS/GNSS
modules (can upgrade to NEO-8 ) and 2.0mm diameter
I-PEX antenna connector with 3.3 voltage power.
Antenna circuit as follows.