44
GETTING TO KNOW YOUR ECS-9200/9100 GTX1050
©Vecow ECS-9200/9100 GTX1050 User Manual
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block located in the back panel. It is below the general wiring
configuration.
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note:
1. DC power source and IGN share the same ground.
2. ECS-9200/9100 GTX1050 supports 6V~36V wide range DC power input in
ATX/AT mode. In Ignition mode, the input voltage is fixed to 12V/24V for car
battery scenario.
3. For proper ignition control, the power button setting should be “Power down”
mode.
In Windows, for
example, you need
to set “When I press
the power button” to
"Shut down."
Pin No.
Definition
1
Ignition (IGN)
2
External Power S/W +
3
External Power S/W +
IGN
V+