44
©Vecow IVH-9204MX ICY User Manual
GETTING TO KNOW YOUR IVH-9204MX ICY
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin pluggable
terminal block located in the back panel. It is below the general wiring configuration.
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
Note :
1. DC power source and IGN share the same ground.
2. IVH-9200 supports 6V to 36V wide range DC power input in ATX/AT mode. In
Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
3. For proper ignition control, the power button setting should be "Power Down"
mode.
In Windows for
example, you need
to set "When I press
the power button" to
Shut down.
Pin No.
Description
1
Ignition (IGN)
2
External Power S/W +
3
External Power S/W +
V+
IGN
