63
©Vecow MTC-6000 User Manual
GETTING TO KNOW YOUR MTC-6000
2.6.2 Ignition Control Wiring
To activate ignition control, you need to provide IGN signal via the 3-pin
pluggable terminal block locates in the back panel. Please find below the
general wiring configuration.
Note :
1. DC power source and IGN share the same ground.
2. MTC-6000 supports 6V~36V wide range DC power input in ATX/AT mode. In
Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
3. For proper ignition control, the power button setting should be "Power down"
mode.
In Windows, for
example, you need
to set "When I press
the power button" to
"Shut down."
Pin No.
Definition
1
Ignition (IGN)
2
External Power S/W +
3
External Power S/W +
IGN
V+
IGN
V+
V+
: Positive polarity of DC power input (Car for 12/24/36V)
V-
: Ground of DC power input (Car battery -/GND line to GND)
IGN
: Ignition signal input (ACC power of vehicle)
For testing purpose, you can refer to the picture blow to simulate ignition signal
input controlled by a latching switch.
