41
©Vecow SPC-5000 User Manual
GETTING TO KNOW YOUR SPC-5000
2.5 Main Board Jumper Settings
2.5.1 Front View of EMBC-3000 Main Board With Jumper Location
The figure below is the top view of the EMBC-3000 main board. It shows the
location of the jumpers.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2, and 3. In this case you would connect either pins
1 and 2, or 2 and 3.
Open
Closed
Closed 2-3
1
2 3
JP10
JP2
JP4
JP9
JP5
