• Always request original spare parts for repairs
• If the product needs to be removed, turn off the
mains supply circuit-breaker and then discon-
nect the fan.
• The fan
MUST BE
installed as detailed in
this leaflet
WARNING: Damage could be caused to the
product if the installation instructions are not
followed
• The product should
not
be used in an ambient
temperature higher than 40°C (104°F).
• The product should
not
be exposed to atmos-
pheric agents (rain, sun, snow, etc.).
• The product or its parts should
not
be
placed in water or other liquids.
• Routine maintenance as described below
should be carried out to check the condition of
the fan.
• The air or fumes being extracted must be clean
and free from greasy particles, soot, chemical
and corrosive agents, flammable or explosive
mixtures.
•
The product must be installed by profes-
sionally qualified personnel. Incorrect
installation can cause damage to people,
animals or property, for which the manufac-
turer cannot be held liable.
• The product must be connected to the electrici-
ty supply via a double pole switch of a suitable
size, with contact openings of at least 3 mm.
• If the electrical supply board (or switching
device) is located some distance from the fan a
means of local isolation must be provided.
• To ensure optimum operation, do not block the
air intake and exit vents.
• Any ducting used must be free of blockages.
• The room where the product is operating must
have adequate air replacement to ensure maxi-
mum effectiveness.
• If the product is sited in a room containing a
fuel burning appliance which is not of the bal-
anced flue type, the installer must ensure that
air replacement is adequate both for the fan
and the fuel burning appliance.
• The product must
not
be used as an activator
for water heaters, stoves, etc.
• The product must
not
exhaust into ducts
designed to evacuate fumes from combustion
in stoves or other combustion-powered
devices.
RANGE
ES1003
- this fan combines the latest technology
with energy saving and efficiency. It is a quiet
running, 3 speed fan. It is designed to run
continuously at a pre-selectable choice of 2 lower
speeds (fixed at installation). The user can boost
the fan speed to its maximum performance when
required by means of the cord or remove the cord
and use a remote switch, light switch, PIR sensor
or humidistat.
The ES1003 is SAP Appendix Q
Listed
.
ES1003CF -
as above, but complete with metal
filter.
ES100H2C
- humidity control model - the fan will
start to operate automatically at its lower speed
when the relative humidity reaches the pre-set
level and will continue to operate at this speed
until the humidity has been dispersed. The user
can use the cord or the remote switch (if the cord
has been removed) to operate the fan (at its high-
er speed), or boost the fan speed if it is already
running. Pulling the cord again (or switching off)
will revert the fan to its lower speed, and it will
continue to run either until the humidity has been
removed, or the fan has completed the timer
over-run period (adjustable between 3 and 25
minutes). The fan's "
comfortimer
” technology
3
Summary of Contents for eSmile
Page 5: ...5 ...
