Installation
IT IS IMpORTANT THESE INSTRUCTIONS ARE READ FULLY BEFORE INSTALLATION
•
This product should not be used for any purpose other than that for which it was designed and as shown
in this leaflet.
•
All packaging should be removed and the unit checked for damage in transit. If there is any damage, please
contact your supplier
•
The EVO90DC will generally be fitted into a loft or ceiling void.
In order to comply with
Construction (Design & Management) Regulations, sufficient access for safe maintenance (recommend
ed on an annual basis), or removal following installation, MUST be provided for this product. See dimen-
sions above.
•
Fire Dampers
must be fitted
to duct work at appropriate locations in accordance with Building Regulations
•
Flue gases from fuel-burning equipment must not be drawn into a living area. If any room from which air
is extracted contains a fuel burning appliance, such as a central heating boiler, then its flue must be of
the sealed or balanced flue type, or allowance must be made for an adequate supply of air into the
room.
•
The unit must NOT be installed:
-
where there is excessive oil or grease
-
where there are hazardous gases, liquids or vapours that are flammable or corrosive
-
in ambient temperatures above 50ºC or lower than 5ºC
-
in humidity levels above 90% or in a wet environment
•
Where possible the unit should NOT be installed directly above a bedroom or living room.
•
The condensation drain
must
be fitted and if insulated, use the equivalent of at least 25mm of insulating
material with a thermal conductivity of
0.04
W/(mK)
•
Care should be taken to ensure that ducting is free from blockages before switching on the unit as this may
invalidate your guarantee
•
External grilles should be located a minimum of 600mm from any flue outlet in accordance with all
Regulations
•
The unit must be connected to a 230v-240v, 50Hz single phase electrical supply.
•
A triple pole isolation switch with contact separation of at least 3mm must be used to connect the appliance
to the fixed wiring when using the Switched Live.
•
The product should only be connected to the mains electricity supply or electrical outlet if:
- your electrical voltage and frequency correspond to those shown on the rating label.
- the capacity of your electricity supply is sufficiently powerful to operate the product at its
maximum power.
•
If one of the spigots is not connected to ducting a safety grille
MUST
be fitted to that spigot, so that it is
impossible for any moving part to be touched.
•
This appliance is not suitable for installation on the outside of a building
Installation of the appliance
MUST
be carried out by a qualified and suitably competent person and should be
carried out in clean, dry conditions where dust and humidity are at minimal levels.
Page 3
EVO90DC
