F
EATURES
•
SAP Q eligible
(MVHR) residential
whole house heat recovery unit for
providing continuous ventilation in
kitchen and up to 6 additional wet
rooms
•
maximum airflow 76 l/sec
•
suitable for areas up to 210m
2
•
up to 79% of heat recovered from
stale air extracted from warm,
moist rooms replacing it with fresh,
filtered, warmed air to create a
constant, comfortable, healthy
environment
•
easy to install and maintain
•
for fitting into lofts, voids, false
ceilings or cupboards
•
variable choice of low (trickle)
speed and boost options for
optimum setting at installation
•
the boost speed can be
triggered by a switched live
connection from a range of devices:
- PIRFF (passive infra red)
*
- DRH240 (dynamic remote
humidistat)
*
- THM (thermostat)
*
- a light switch (if more than
one light switch is used,
each
one must be a double pole
switch)
- a remote switch/pull cord
(
*
PIRFF, DRH240 and THM may
have integral over-run timer
which controls the length of time
that the fan will continue to
operate at its boost speed after
the boost has been switched off.)
•
low noise levels
•
low running costs
•
gives extra security by removing
need to open windows
•
3 year warranty
•
Vectaire Ltd can supply all
accessories for use with these
units, including air filter cassettes,
silencers, fire dampers, air valves,
ducting, outside grilles and wall
cowls
S
PECIFICATION
•
compact, low profile unit -
only
200mm deep
•
casing manufactured from gal-
vanised sheet with an epoxy finish
•
thermo-acoustic lining in poly-
propylene to prevent thermal
bridging to outside
•
low energy DC brushless motor for
optimum combination of high
performance, low noise levels and
low energy consumption
•
impellers are single width, single
inlet, direct drive and backward
curved for higher efficiency
•
operates in temperatures up to
60ºC
•
pre-wired for easy electrical
connection
•
uses standard, disposable G3
filters
•
counter flow heat exchanger for
greater efficiency and increased
separation of airflows
Vectaire Ltd offers a design service
to ensure that the unit installed is
the best possible to provide efficient,
effective, low energy and low running
cost ventilation. Vectaire can also
organise installation and
commissioning of these products
Tel: +44(0)1494 522333
Fax: +44(0)1494 522337
Email: sales@vectaire.co.uk
Web: www.vectaire.co.uk
Incoming fresh air
Warmed fresh air
Extracted warm, moist, stale air
Cooled outgoing stale air
WHHR100/90DC
L
OFT OR
V
OID
I
NSTALLATION
C
OMPLIES WITH
•
Part L1A and L1B of Building
Regulations for enhanced energy
saving capability
•
Part F of Building Regulations for
reliable, efficient ventilation
•
manufactured to BS EN ISO 9001
•
complies with IEC 60335-2-80,
LVD2006/95/CE and EMC
2004/108/CE European
Directive against radio interference
and electro-magnetic compatibility
•
CE marked
•
SAP Q eligible
Whole House Mechanical Ventilation with Heat Recovery - MVHR
WHHR100/90DC
Technical Characteristics
Page 13
