8
Vectaire WHHRC180DC
Chapter 5
Installation
7KH ¿JXUH EHORZ VKRZV WKH PHWKRG IRU FRQQHFWLQJ D ZD\
switch,
$ ZD\VZLWFKZLWK¿OWHULQGLFDWLRQVZLWFKZLWKPRGXODUFRQ
QHFWRUFRUHFDEOHWZRPRGXODUFRQQHFWRUV5-
The colours of the wires C1 to C6 respectively, indicated in the diagram above may vary, that depends on the type
of modular cable used.
:LULQJGLDJUDPZD\VZLWFKZLWK¿OWHULQGLFDWLRQZLWKPRGXODUFRQQHFWRU
(Note that for both modular connectors the “tab” must be mounted on the side of the mark on the modular cable)
5.5.3 Connecting the power
The appliance should be connected to the mains circuit by a
TXDOL¿HGHOHFWULFLDQ7KHHOHFWULFLQVWDOODWLRQPXVWFRPSO\ZLWK
the regulatory requirements.
Warning
The fans and controls carry a high voltage. Al
ways disconnect from the mains supply when
working on the appliance.
5.5.2 Connecting the OpenTherm connector
,Q FRPELQDWLRQ ZLWK GHPDQGFRQWUROOHG YHQWLODWLRQ WKH DS
pliance can also be controlled with the OpenTherm protocol
LQVWHDGRIDORZYROWDJHVZLWFK2SHQ7KHUPDOORZVFRQWLQXRXV
DGMXVWPHQW RI WKH USP IRU WKH ÀRZ UDWH$ FRUH ORZYROWDJH
cable with a core diameter of at least 0.8 mm
2
must be used
as connecting cable
.
. Interchanging the cable connection to the
SROHVFUHZFRQQHFWRUGRHVQRWLQÀXHQFHWKHDSSOLDQFHVSHU
formance.
