Example: Celsius 400 Degree changed to
350 degree.
1, Press the "*" key and hold at least 1 Second most
The left digit (hundreds digit) will flash. table
Indicates that the temperature of the soldering station is in the setting mode.
Bits can be adjusted.
1.
2, Select the desired value to replace the hundreds. use
"▲" or "▼" key to change the display
The values are shown in the figure below:
…
2
3
2 .
4 …
When the desired digit is displayed, press the * key.
The middle digit (ten digit) starts to flash, indicating
The ten digits can be set.
3.
3. Select the desired value to replace the tens place. use
"▲" or "▼" key to change the display
The values are shown in the figure below:
1 • 2 • 3 • 4 • 5 • 6 • 7 • 8 • 9 • 0
Press the * key.
The right digit (ones digit) starts to flash, indicating
The ones place can be set.
4 .
4. Select the desired value to replace the ones place. use
"▲" or "▼" key to change the display
Numerical value, select the tens position as shown above
law. Press the * key
Here, press the * key...
a. Enter the set temperature into the internal record
Memories
b. Display the set temperature
c. Start heater control
Summary of Contents for SD-150
Page 28: ......