47
48
Operation
Operation
AC/DC WIG SERIES EQUIPMENT
AC/DC WIG SERIES EQUIPMENT
1. Digital Ammeter / Parameter meter
The digital Ammeter is used to display the actual output current of the power source. It is
also used to display Parameters in Programming Mode.
Depending on the Programming Parameter selected, the status indictor adjacent to the
Ammeter will illuminate to show the units of the programming parameter.
When welding, the Ammeter will display actual welding current.
2. Hot Start
Arcforce Correction
Hot Start
Function reliably ignites the electrode
and melts perfectly to ensure the best quality
even at the start of the seam. this solution makes
lack of fusion and cold welds a thing of the past
and significantly reduces weld reinforcement.
Adjust the hot start current here and the time here.
During the welding process, arcforce prevents
t h e e l e c t r o d e s t i c k i n g i n t h e w e l d p o o l w i t h
increases in current. this makes it easier to weld
large-drop melting electrode types at low current
strengths with a short arc in particular.
I
t
Anti-stick prevents the electrode from annealing.
If the electrode sticks in spite of the arcrorce device, the
m a c h i n e a u t o m a t i c a l l y s w i t c h e s o v e r t o t h e m i n i m u m
c u r r e n t w i t h i n a b o u t 1 s e c o n d t o p r e v e n t t h e e l e c t r o d e
f r o m o v e r h e a t i n g . I n o r d e r t o e a s i l y s e p a r a t e t h e
e l e c t r o d e a n d e l e c t r o d e h o l d e r t o p r o t e c t t h e w e l d e r.
Antistick
A
n
ti
s
ti
c
k
U
I
3. Mode Button
Press the MODE button to toggle AC and DC output in LIFT TIG, HF TIG.
4. Current adjusting button/functions choosing
Clockwise rotate to enlarge the current, and anti-clockwise rotate to reduce the current.
If you need to choose different programming parameters (the thirteenth mark), press the
button and release it to choose different functions.
6. Current Indicator
When setting programm in the peak current, base current, ending current and rem , this
current indicator will be on.
5. Time Indicator (s)
Time indicator , when setting programm in gas pre-flow, up slope, down slope and gas
post-flow, this indicator will be on.
7. Percentage Indicator(%)
Percentage indicator, when setting programm in pulse duty cycle , this indicator will be
on .
19
18
Behind