55
5
NOZZEL HATCH
COVER
NOZZLES
PRESSURE
GAUGE
2.
ADDITIONAL KEY FEATURES
• Trigger Switch with lock to allow hands free operation
• Corded -includes a DC power adapter for use with standard 12 volt
power supply
• Battery Pack includes non-spillable, maintenance-free, heavy duty, sealed,
high-density lead-acid battery
• Requires no maintenance (other than recharging and cleaning) for
optimum operation
• Supplied 110 volt AC charger is Underwriter Laboratories (UL) safety
tested and listed
• Battery Charging LED on battery automatically activated during
AC recharge
• Analog Pressure Gauge to 260 PSI
• Nozzle Hatch for storing nozzles
FIGURE 2
CAUTION:
This unit is delivered in a partially charged state - you must
fully charge it before using it for the first time. Initial AC Charge should
be for 10 hours. Refer to section 5 for use of AC Adapter and
detailed charging instructions.
3.
ATTACHING THE AIR HOSE
The Air Hose is supplied as a separate item from the compressor body. The
hose has a ribbed brass fitting at one end and a standard tire chuck at the
other end. To use the hose it must first be connected to the compressor outlet.
Loosen the hose retaining ring (counterclockwise), insert the hose fitting
into the short, rubber sealing sleeve. Make sure the hose fitting is inserted
fully into the sleeve. Partially tighten (clockwise) the hose-retaining ring and
push the fitting in further. Do this two or three times until the fitting is firmly
attached and the ring is firmly tightened.
WARNING:
Improperly attached hoses or nozzles can fly out under
compressor pressure. Make sure the connections are tight.
