background image

8

IMPORTANT:

Always leave the tire chuck thumb latch in the open position when storing unit.

6.2

INFLATE OTHER ARTICLES (WITHOUT VALVE STEM)

Inflation of items, others than tires, requires use of one of the nozzles (adapters). 

A nozzle can be attached to the tire chuck, or it can directly be connected to the 

compressors outlet, if the hose is removed.

A nozzle can be attached to the tire chuck. Open the nozzle hatch cover and remove

the required nozzle. Close the nozzle hatch cover. Place the tire chuck over the nozzle

fitting and secure by moving the chuck thumb latch so it is parallel with the hose. Make

sure the nozzle is clean and secure before turning on the compressor. After use, release

the nozzle from the chuck by lifting the latch. Return the nozzle to the nozzle hatch.

A nozzle can also be directly attached to the compressor outlet if the hose is not required.

1.   Open the nozzle hatch cover and remove the required nozzle.

2.   Remove the hose from the compressor outlet by loosening (counterclockwise) the

hose retaining ring and sliding out the ribbed brass fitting.

3.   Close the nozzle hatch cover.

4.   Insert the selected nozzle into the compressor outlet and secure it by tightening the

hoseretaining ring as above.

5.   After using the compressor, remove and store the nozzle in the nozzle hatch.

Refer to “Typical Inflation Times” for approximate pressure and time. Small items like

volleyballs, footballs, etc. inflate very rapidly.

6. Insert nozzle (e.g needle) into item to be inflated and inflate to desired pressure.

7. Turn on compressor switch - inflate to desired pressure or fullness.

7. TYPICAL 

INFLATION TIMES FOR COMPRESSOR USE

The following are approximate pressure and inflation times for various items:

WARNING: 

Always follow tire manufacturers recommendations for pressure on item to be inflated.

VEHICLE AND TRAILER TIRES

TIRE SIZE       

PRESSURE        

TIME FROM “0” PRESSURE

155/80R 13"     

26 psi  

2.50 min.

185/70R 14"     

30 psi  

4.50 min.

235/75R 15"     

30 psi  

6.50 min.

235/85R 16"     

50 psi  

16.00 min.

BICYCLE TIRES

TIRE SIZE       

PRESSURE        

TIME FROM “0” PRESSURE

27 x 1" racing  

10 psi  

40 sec.

INFLATABLE ARTICLES

ITEMS       

PRESSURE        

TIME FROM “0” PRESSURE

Football        

13 psi  

24 seconds

Basketball      

9 psi   

20 seconds

Volleyball      

5 psi   

6 seconds

7

FIGURE 4

To remove the battery pack from the appliance body for charging: make sure the

trigger switch is OFF. Press both battery pack release buttons at the same time. Pull

the battery pack down away from the appliance body. Insert the barrel connector of

the AC adapter into the battery pack’s receptacle (recharge port). Plug the AC adapter

into a 110 volt AC standard household receptacle. Observe the red LED lights. Charge

for the recommended time. Do not overcharge! Disconnect and store the AC recharge

adapter from the battery pack and AC source when not in use.

6. COMPRESSOR/TIRE 

INFLATOR

This 12 volt DC compressor is the ultimate compressor for all vehicles, trailer tires and

recreational inflatables. Three different sized nozzles are supplied.

IMPORTANT: 

Read safety instructions carefully to avoid possible injury or property damage.

WARNINGS: 

The compressor is capable of inflating to 260 pounds per square inch (PSI) pressure

(approximately 18 kg/cm).  To avoid over-inflation, carefully follow instructions on

articles to be inflated. Never exceed recommended pressures. Bursting articles can

cause serious injury. Always check pressure with the pressure gauge. Never leave

compressor unattended while in use. Allow unit to cool for five minutes after 10 minutes

of continuous operation.

6.1

TIRE INFLATION OR PRODUCTS WITH A VALVE STEM

1.   Place connector (chuck) on valve stem.

2.   Push connector toward valve stem and close thumb latch.

3.   Make sure connector is pushed on to valve stem as far as possible before closing

thumb latch.

4.   Turn on the compressor (for larger items the trigger can be latched).

5.   Observe pressure with the pressure gauge.

6.   When desired pressure is reached, open thumb latch and remove connector from

valve stem.

7.   Turn off compressor power switch

CONTACT

RECHARGE PORT

RECHARGE  LED

RELEASE BUTTON

110 VOLT AC 

WALL ADAPTER 

WITH CORD

VEC258 Manual 3/03.qxp  1/23/07  5:18 PM  Page 7

Summary of Contents for AIRPRO VEC258








Reviews: