16
To check the battery status, press the Battery Status Display Push-button. If the
Jump-Starter’s battery is fully discharged, it is recommended that the host
vehicle or boat’s engine being used for recharging be left operating while the
unit is being charged using the 12 Volt DC/DC method.
WARNING:
DO NOT recharge main unit for more than 8 hours maximum
using 12 Volt DC method. After charging, disconnect the cables and store
them in the Cable Storage Area.
8.3
Simultaneous Recharge and Inverter Operation
The inverter can be operated to power up to 80 watts during battery recharge.
This will slow recharge, but ElectroMate can be used as a UPS system.
9 . Maintenance/Replacement Parts
For replacement parts, cables, etc, contact Vector Technical Support: toll-free
(866) 584-5504. ElectroMate is modular in construction. If the charger, lamp,
compressor or inverter require service, unit should be returned to Vector. Note
that the inverter can be shipped back mounted to the battery compartment
cover. Periodically, the cables and connectors should be inspected for dam-
age, corrosion, dust and dirt. If surfaces are dirty, they can be wiped clean
with a cloth moistened with water and a small drop of detergent. Contacts can
be wiped clean with a dry cloth.
WARNINGS:
There are no user serviceable parts inside. Do not operate
unit if there is any evidence of damage. The product must be returned to
Vector for testing and repair. Replace any damaged cables immediately
before further use.
1 0 . Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which
must be disposed of properly. Recycling is required. Contact your local
authority for information. Failure to comply with local, state and federal
regulations can result in fines or imprisonment. Sealed lead-acid battery must
be recycled or disposed of properly.
Battery Disposal Warnings:
1.
Do not dispose of the battery in fire as this may result in an explosion.
2.
Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting (shorting can result in
injury or fire).
3.
Do not expose battery to fire or intense heat as it may explode
