Run
9
________________________________________________________________________________________
_______________________________________
9
-
61
9.3.2 Advanced Controls: Trimmer
These settings are:
Trim Forward Pressure
When set to OFF, trimmer advance pressure is OFF when
trimmer is turned OFF. This can be useful if producing shapes
outside specification where the banding can be performed but
the trimmer will interfere. This allows the trimmer to float.
Start Trim 360 (0.1mm)
Distance from commencement of edgeband to the point where
the trimmer starts trimming for a 360 degree (butt join) panel.
Note the trimmer must start after the band start to leave a clear
underhang for the butt join arm to measure.
Trim run on 360 (0.1mm) Distance from the end of the band to when the trimmer and
scraper finish.
Start trim non-360
Distance from commencement of edgeband to the point where
the trimmer starts trimming for a non-360 degree (open) panel.
Trim run on non-360
Distance from the end of the band to when the trimmer and
scraper finish.
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...