Run
9
________________________________________________________________________________________
_______________________________________
9
-
62
9.3.3 Advanced Controls: Scraper
These settings are:
Concave Scrape
When this is set to OFF, the scraper will automatically lift off when the
curve becomes concave. It will automatically recommence when the
edge straightens again or goes convex.
On internal radii less than 300mm, the scraper will move over the
panel away from the edge and on fragile surfaces, this may mark the
surface, hence it is possible to turn the scraper off in this situation.
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...