Run
9
________________________________________________________________________________________
_______________________________________
9
-
75
9.4.3.3
Aggregate pushed back by bump switch (914)
If the shape of the panel is such that the aggregate will not be pushed back naturally by
the shallow shape of the panel, it is necessary to Enable the Concave Sensor (970).
Refer 9.3.6 Advanced Controls: Panel Shapes. This serves the dual purpose of
enabling the Concave Sensor (910) and also the Bump Switch (914). Refer 9.4
The bump switch is activated when the shape of the panel pushes on the end of the Bump
Switch slide lever (926) causing it to activate the bump switch sensor.
926
920
970
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...