Run
9
________________________________________________________________________________________
_______________________________________
9
-
82
By turning on any combination of the options in this column, the corresponding row value
will over-ride the existing machine settings.
For example, by turning on the Glue Back function (992), the Glue Station will retract until
further notice.
Similarly by turning on Speed 1 at (993), the speed will be over-ridden by the value you
enter into the Speed field at (994).
These values will be maintained until either, the Auto Off position is reached (995) or the
second column (996) is initiated.
Any combinations of the line items are able to be turned on at each countdown point and
so it is possible for example to maintain speed 1 through each count downpoint while
turning the glue station back, on and off.
If the column count value eg (996) is 0, it is ignored.
The Auto Off position (995) is set by determining when you wish the entire Special
Sequence to finish (by jogging through the condition) and the inserting the feed count
(990) for this position.
This will reset the entire Special Sequence in preparation for future Special Sequences.
The following is a description of each of the Special Sequence control items:
Glue Fwd
When ON, the Glue Station is forced forward.
Glue Back
When ON, the Glue station retracts until it reaches the glue back 45
sensor and will then float with pressure on both sides of the air
cylinder.
Join Sensor Arm
When OFF, the join sensor arm will remain retracted.
Speed 1
When ON , Speed 1 setting (994) is maintained
Speed 2
When ON , Speed 2 setting (930) is maintained
Bias 1
When ON , Bias 1 setting (931) is maintained
Bias 2
When ON , Bias 2 setting (932) is maintained
C Pressure 1
When ON , C Pressure 1 setting (933) is maintained
C Pressure 2
When ON , C Pressure 2 setting (934) is maintained
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
