Care and Maintenance
10
________________________________________________________________________________________
_______________________________________
10
-
1
10.1 General instructions
Refer to the chapter “Safety” during maintenance and inspection work.
The power must be disconnected from the machine at its supply socket before
work is started on the machine.
Depressurise the pneumatic supply system!
•
Clean the machine/unit daily.
•
Remove shavings with a suitable brush or with an approved extractor system
suitable for PVC shavings where applicable.
•
When blowing the machine clean using compressed air, do not aim the air jet
into the bearings or guideways.
•
Lightly grease all moving parts such as sliding surfaces, adjusting spindles and
guides whenever required.
Pollution of the environment.
Waste material of all kinds should be disposed of in an environmentally
friendly way and in compliance with local recycling and disposal procedures.
DANGER !
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...