Transport, offloading, setting up
4
________________________________________________________________________________________
_______________________________________
4/3
Fig 1
Fig 2
The machine should be pushed between 500 – 1000mm into the container clear of
the doors so as to give the strops a good purchase.
At the rear of the container, three strops are used. One ties from the rear left of the
container, forward and across behind the rear horizontal cross-member and looping
back to the corner tie point.
The machine can be pulled from the container using the strop (4) which can also be
used to support the end of the machine as it comes out through the container.
1
4
Summary of Contents for Revolution 180
Page 1: ...Operating Manual...
